diff options
Diffstat (limited to '')
| -rw-r--r-- | private/ntos/ndis/madge/driver/ftk.upd | 279 |
1 files changed, 279 insertions, 0 deletions
diff --git a/private/ntos/ndis/madge/driver/ftk.upd b/private/ntos/ndis/madge/driver/ftk.upd new file mode 100644 index 000000000..a1dc10fa1 --- /dev/null +++ b/private/ntos/ndis/madge/driver/ftk.upd @@ -0,0 +1,279 @@ +/**************************************************************************** +* +* FTK.UPD +* +* FastMAC and FastMAC Plus Toolkit +* +* Copyright (c) Madge Networks Ltd 1991-1994 +* +* COMPANY CONFIDENTIAL +* +****************************************************************************/ + +/*--------------------------------------------------------------------------- + + Update History + +----------------------------------------------------------------------------- + +2.21.12 PBA 17/07/1995 + + Fixed a bug in hwi_pci.c. We were doing MMIO processing + if either the TX or RX bit in SIFINT was set without + requiring the host interrupt bit to also be set. This + meant that if we were on a shared interrupt we could + do an erroneous MMIO transfer because the RX or TX was + set but the adapter had not generated an interrupt. + +2.21.11 PRR 11/07/1995 + + Added another PCI fix to all the PCI cards, when using PIO + we need to handshake the transfer because of some PCI/Eagle + problems. + +2.21.10 PRR 10/07/11995 + + Added the fix for the PCI-Ti ASIC for DMA, also found a bug in + the ISR which is worth noting. To check for Pseudo DMA we need + to check the SWHRQ and PSDMAEN bits we were just checking SWHRQ + (DMA in progress). This causes a few problems if we go into the + Pseudo DMA code whilst in DMA mode. + +2.21.09 PRR 05/07/1995 + + Added the new fix to DMA on the PCI-Ti card. + +2.21.08 PRR & PBA 28/06/1995 + + Added the WinBook PCMCIA fix. Define WIN_BOOK_FIX + to enable it. + +2.21.07 PBA 22/06/1995 + + Fixed a bug where hwi_gen.c was not setting the MAC + buffer size to 504 bytes for PCIx adapters. + +2.21.06 PRR (& PBA) 21/06/1995 + + Finished support for TI ASIC based PCI adapter. + +2.21.05 PBA 24/05/1995 + + Fixed a bug in hwi_eisa.c where interrupts were not + being regenerated properly. Only affected edge triggered + interrupts. + +2.21.04 PBA 24/05/1995 + + Added support for the mark 3 EISA adapter. + +2.21.03 PRR 02/05/1995 + + Support for PCI-Ti and PCI-BM cards added. + The Ti one is works with all 3 demo programs in Pseudo-DMA + mode, the ASIC does not work for DMA so I have not tested it. + The BM code is as yet untested because of Silicon features. + +2.21.02 PBA 12/05/1995 + + It appears that certain sorts of PCMCIA socket + controllers can generate stray interrupts as soon as + we touch the adapter. Re-ordered some of the interrupt + initialisation code so that we can cope with the stray + interrupt. + +2.21.01 PBA 07/04/1995 + + Changed hwi_pci.c so that is uses the extended + handshake on transmit MMIO. + +2.21 PD 03/04/1995 + + Second version of the combined FastMAC and FastMAC + Plus toolkit. Uses FastMAC v4.50 and FastMAC Plus v1.34. + +2.20.27 PD 09/02/1995 + + Added a pokeouts module to allow debug information to be + sent to the serial ports on an IBM or clone. See head_def\ + ftk_poke.h for the macros to use. + Also altered hwi_pcmc.c with calls for point enabling a + PCMCIA adapter. They are protected by #ifdef PCMCIA_POINT_ + ENABLE. The prototypes for the calls are in sys_pcmc.h, but + no example DOS sys_pcmc.c or sys_pcmc.asm file is included. + DOS programs should use MADGECS or similar to provide card + and socket services - in which case the point enabler code + is not required. + +2.20.26 PBA 23/01/1995 + + hwi_pcmc.c now sets the MC_AND_ISACP_USE_PIO flag in + the adapter->mc32_config byte to get the software + handshake to work properly. + +2.20.25 PBA 12/01/1995 + + Removed bug in driver_remove_adapter where the FastMAC + Plus dma test buffer was freed if the pointer was NULL + rather than not NULL! + +2.20.24 PBA 12/01/1995 + + Changed hwi_get_node_address_check so that it doesn't + check for a Madge node address so that the FTK will + work on none Madge adapters. + + Also changed drv_init.c so that the Madgic bits are only + set if MADGIC_BIT is defined. This allows support for + Madgic bits to be removed with RIFFDEF for releases. + +2.20.23 PBA 03/01/1995 + + Changed sys_allocate_dma_phys_buffer and + sys_free_dma_phys_buffer so that they take a DWORD + for the memory block size. + +2.20.22 PBA 12/12/1994 + + Tidied up some differences between the PCMCIA FTK and + HWI to do with interrupt regeneration that was causing + Windows95 to hang occassionally. + +2.20.21 PBA 12/12/1994 + + There us a problem with pseduo DMA on PnP and Smart16. + We have to read SIFACL, set the SINTEN bit and write + it back to regenerate interrupts. However, sometimes + when we read SIFACL the SWHLDA bit has not been cleared + by the Eagle. If at the same time the SWHRQ bit has been + set by the Eagle to indicate another transfer is pending + we may accidentally start another transfer when we write + the value of SIFACL + SINTEN back. The solution is + to poll SIFACL until the SWHLDA bit is cleared. This + fix gets rid of the delay in 2.20.19. + +2.20.20 PBA 08/12/1994 + + Added 32 bit PCMCIA support. + +2.20.19 PBA 08/12/1994 + + Put the code back that was removed in 2.20.17. Under + NT/Win95 we seem to need a short delay at the pointer + where under DOS we would clear the interrupt controller. + +2.20.18 PBA 07/12/1994 + + Added code in hwi_pcmc.c to call user_adapter_removed + if the PCMCIA adapter goes away. Enabled by defining + FTK_ADAPTER_REMOVED_NOTIFY. + +2.20.17 PBA 06/12/1994 + + Removed some code in hwi_pnp.c and hwi_sm16.c that toggled + EAGLE_SIFACL_SINTEN. I don't know why this code was there + and it breaks the hwi. + +2.20.16 PBA 06/12/1994 + + Now sets the "Madgic" bits. + +2.20.15 PBA 06/12/1994 + + Added lots of casts to stop the NT compiler from generating + warnings. + +2.20.14 PBA 06/12/1994 + + Added compile directive FTK_NO_TX_COMPLETION_CALL that + stops drv_irq.c calling rxtx_irq_completion_check even + if we have asked for TX complete interrupts by defining + FTK_TX_WITH_COMPLETION. + +2.20.13 PBA 02/12/1994 + + Fixed a bug in hwi_sm16.c where the node address wasn't + read properly because of an unitialised variable. + +2.20.12 PBA 01/12/1994 + + Changed the minumum number of RX/TX slots to 2. + +2.20.11 PBA 01/12/1994 + + Removed the calls to driver_remove_adapter in + driver_prepare_adapter, otherwise there's + no way to return an error message. + +2.20.10 PBA 01/12/1994 + + Fixed some places where macro_enable_io calls where + not enclosed by an #ifndef FTK_NO_IO_EMABLE. Also + changed an errant sys_probe_insb to a sys_insb. + +2.20.09 PBA 01/12/1994 + + Changed sys_sync_with_interrupt so that it takes an + abapter_handle parameter and returns a WBOOLEAN. Also + moved the definition to sys_mem.h. + +2.20.08 PBA 01/12/1994 + + Added a tx_flags parameter to rxtx_transmit_frame. + +2.20.07 PBA 30/11/1994 + + Fixed driver_prepare_adapter so that it always + calls driver_remove_adapter if it fails to + free up any memory allocated. + +2.20.06 PBA 29/11/1994 + + Initialise time functions are now marked with + #pragma FTK_INIT_FUNCTION(...), interrupt time + functions with #pragma FTK_IRQ_FUNCTION(...) + and run time but not interrupt time functions with + #pragma FTK_RES_FUNCTION(...). The #pragma's are + prefixed by #ifdef FTK_xxx_FUNCTION. The + FTK_xxx_FUNCTION definitions should be in user.h. + +2.20.05 PBA 21/11/1994 + + Change get_bring_up_code to retry the bring-up up to + 10 times. There is a problem with ICL PCs/ATPs with + SMARTNT.SYS where the bring up occassionally fails. + Retrying is the way the HWI fixes it. + +2.20.04 PBA 18/11/1994 + + Changed driver_open_adapter so that it takes the product + instance id from the string ftk_product_inst_id. This + string is initialised to FASTMAC_PRODUCT_ID so if + the user doesn't do anything it behaves as before. + However the user can change the string before calling + driver_open_adapter. + +2.20.03 PBA 16/11/1994 + + Fixed HWI_PCMC.C which was not setting the RAM size in + the adapter structure. + +2.20.02 PRR 16/11/1994 + + Change the polling routing for PNP cards such that it only + looks for md not md01. + +2.20.01 PBA 16/11/1994 + + Fixed spelling mistake in user.h of header files. + FTK_NO_PROBING should have been FTK_NO_PROBE. + +2.20 PD & PBA 15/11/1994 + + First recorded version of the combined FastMAC and FastMAC + Plus toolkit. Heaviliy revised from v1.x and the 2.x + beta. Uses FastMAC v4.48 and FastMAC Plus v1.22. + +---------------------------------------------------------------------------*/ + +
\ No newline at end of file |